This Page Is Proudly Hosted By:

IceStuff.com

A Place For All Your Stuff!

Be The First To Know About Energy Additions & Updates - Click Here

The Ion Wind Tests on Transdimensional's Lifter
By Jean-Louis Naudin
created on October 10th, 2001 - JLN Labs - Last update October 15th, 2001
All informations in this page are published free and are intended for private/educational purposes and not for commercial applications


In the Birmingham Business Journal ( July 19, 2001 ) we can read : " The scientific community has also mistaken Power3 for ion wind propulsion, although Transdimensional says ion wind contributes less than 2 percent of the system's total motive force. "

So, I have conducted two tests to check if the fact of removing the ion wind is able to cancel the upward thrust.

Ion Wind Test #1 :

The Lifter1 that previously tested on Oct 1, 2001, has been used for these tests. The three thin copper wires has been completly insulated with Three 5 mm diam plastic tubes so as to remove the ion wind previously generated by these thin wires.

With these plastic tube the Lifter1 is not able to self-levitate, so it has been placed on a Roberval balance and insultated with a polystyren box.

TEST RESULT : When the High Voltage power supply is switched ON ( 41.9 KV @ 90uA - 37.7 Watts ), the Lifter1 goes upward and the needle of beam balance move to the left. ( see the photo and the video of the test below )

To see the videos, the free downloadable RealPlayer is required

The Ion Wind Test #1

Click on the picture above to see the video ( 533 Kb )

Ion Wind Test #2 :

To check again if the main lifting thrust is not generated by the ion wind. I have used a thick cardboard sheet between one wire and the main armature. In the case of the ion wind generates all the thrust, when a cardboard shield is placed below one of the wires, the Lifter must tilt on one side due to the resulting asymmetrical flow.
A such test has also been performed by Transdimensionnal Technologies ( see :
http://www.tdimension.com/video_pages/lifter_ion.htm )

TEST RESULT : When the High Voltage power supply is switched ON, the device remains stable and continue to hovering at the same level. ( see the photos and the videos below )

The Ion Wind Test #2

Click on the picture above to see the video ( 978 Kb )

Conclusion : It seems that after these two tests, that the ion wind generated by the thin wires isn't the source of the main upward thrust observed on the Lifter device.


Email : JNaudin509@aol.com


Return to the Lifters Experiments page


Encyclopedia of free energy now on CD click for more information

Google
 
Web www.IceStuff.com

Click Here To Email Questions Or Comments To The Webmaster

IceStuff.com has served pages for Energy21 since January 1, 2008